GATE PECKER (MODEL SELECTION)

MODEL SELECTION

To select a Gate Pecker model, consider the following.

・Applicable Models

・Model Section Guide

・Breaking Power

●　APPLICABLE MODELS

Layout	Tool						STRUCTURE PLAN
	Type	Breaking Power(t)
	Type	5.5	9	14	27	40
Waist Level	Standard	GP-MN	GP-DM	GP-5VS			No.1
Waist Level	Flexible		GP-DF	GP-5FK	GP-10S		No.2
Floor Level	Flexible				GP-10F	GP-20F	No.3
Floor Level	Standard			GP-5LV	GP-10M	GP-20	No.4

STRUCTURE PLAN

：

For an overview, see STRUCTURE PLAN (PDF*)No.1，No.2，No.3， and No.4.

*	To view the STRUCTURE PLAN, you need Adobe Reader installed. If you do not have Adobe Reader installed, please download it by Left Button (free of charge).

●　MODEL SECTION GUIDE

In model selection, narrow it down to the most suitable model while considering the following conditions.

1.	Casting Material	：				(Tensile strength　　　㎏/㎜²)
2.	Sectional Area of Gate	：		㎜×	㎜
3.	Weight	：	Weight in isolation		㎏/piece
4.	Uses	：	①Separating Gate		②Separating Runner	③Separating Side Riser	④Separating Top Riser
5.	Molding Machine	：
6.	Frequency of use	：	①8 Hours/Day		②16 Hours/Day	③Other
7.	Layout	：	①Floor Level Line		②Waist Level Line
8.	Operation	：	①Before shot		②After shot
9.	Voltage	：		V	Hz

●　BREAKING POWER

The Gate Pecker's breaking power varies greatly with the conditions specified in the casting plan and other plans. For Material FCD-450, refer to the following guide.

Model	Breaking Power Ton	Maximum Breakable Sectional Area 　㎜² 　　　(㎜×㎜)
GP-MN	5.5	100　　　(10×10)
GP-DM(DF)	9	200　　　(15×15)
GP-5LV(5VS,5FK)	14	440　　　(21×21)
GP-10M(10F,10S)	27	1,100　　　(33×33)
GP-20(20F)	40	3,000　　　(55×55)

For gate separation with the Gate Pecker, it is extremely important to use the following effectively
	1)Distance between the bill and breaking point.
	2)Separator notch.
To separate work of Material FCD-450 with a GP-10M, for example, the breaking power with tensile strength alone will be
	1,100㎜²×45㎏/㎜²＝49,500㎏<49.5ton>
Even if the friction coefficient is excluded, the GP-10M with a breaking power of 27 ton cannot complete the separation. The key point in this case is therefore to make effective use of 1) and 2).

<NOTE>	If there are two or more gates, be sure to begin with the edge of side A in the separation, then process the remaining gates in order.

CASTING PLAN

：

For an overview, see CASTING PLAN(PDF*).

*	To view the CASTING PLAN, you need Adobe Reader installed. If you do not have Adobe Reader installed, please download it by Left Button (free of charge).